How it works
How AskMyAds manages your Google Ads - approval-first.
It reads your account and your website, answers what you ask in plain words, and proposes exact changes. Nothing is applied until you say yes, and every change has one-click undo.
Ask, draft, approve
Four steps, and you hold the only yes.
The whole loop on one channel - Google Ads - from a read-only connection to a change you approved and can undo.
- Writes nothing
Connect read-only, then ask
You connect Google Ads read-only and add your website, so the agent knows what you sell and where you deliver. It writes nothing. Ask it anything about the account, or ask for the free Waste Scan first: it reads what you already paid for and finishes in about five minutes.
- From your own metrics
Get the answer with its numbers
Every figure in an answer is computed from your account's own metrics, never a model's estimate, and the table it came from is shown next to the sentence. A scan's total is a conservative lower bound on what was avoidable, so a scan that finds nothing says so instead of inventing a number.
- Still a draft
Get the exact change, as a draft
Ask what to do about a finding and the agent drafts the exact change: the campaign, the setting, the negative keywords, line by line. It stays a draft. A reply in chat is never approval, and nothing has touched Google Ads yet.
- One-click undo
Approve it, and undo it if you want
You approve the change on screen, and only then does it run - through spend guardrails and a preflight check, with a receipt of what ran and when. Every change has one-click undo, and new campaigns are created paused so nothing spends until you enable it.
What you can ask for
See pricingAd platforms were built for professionals. You should be able to ask a question anyway.
A retainer buys a team's attention, and it is priced for accounts that need a team. Most accounts need answers. AskMyAds already knows your Google Ads account and your website. Ask it how the ads are doing, what to change, or what a new campaign should look like. It answers with the numbers, drafts the exact change, and nothing happens without your approval.
Explain it plainly
No dashboards to decode. Ask how last month went and the answer names the number that matters - zero conversions on $287.73 and 171 clicks - then says what it thinks is causing it.
Show the numbers behind it
Every figure in an answer is computed server-side and shown to you, so you can check the prose against the table it came from rather than take the sentence on trust.
Ask it to find the waste
The free Waste Scan is the first thing to ask for. Connect your Google Ads account with read-only intent. AskMyAds checks campaign settings, search terms, targeting, and conversion signals, then reports what the account wasted - with a dollar figure calculated from its own metrics. You get a conservative lower bound on what was avoidable, tied to the findings behind it. Every figure comes from deterministic, read-only checks - nothing is estimated by a model. Example account shown - the dated scan of my own account is on the Waste Scan page.
Fix it with a yes
Every fix is shown as an exact change, applied only after you approve it, and undone with one click. A new campaign is drafted the same way and created paused. A chat reply is never approval.
Start with the free Waste Scan.
It is the first thing to ask for. In about five minutes, read-only, it names what your account wasted last month in dollars from your own numbers. Then keep asking: how the ads are doing, which keywords to add, what a new campaign should look like. Any fix it suggests waits for your approval, and so does any campaign it drafts.
Run your free Waste Scan- Read-only scan; nothing changes while it runs
- Findings in dollars, from your own account's metrics
- Then ask anything: performance, keywords, a campaign draft
- Free Waste Scan - no card required
- Every change shown first, applied on your yes, undone in one click